The basic dimensions for these are:
6mm Thick
4 x 100 PCD
140mm Overall Diameter
48mm Hole through the middle
55.9 outside diameter spigot
56mm inside diameter recess in the rear
4mm tall nose on the face
These will fit on the front axle of Rover R8s (and probably R3s). The only minor changes made between these and the later ones were the holes for the wheel studs were enlarged (you can drill these out if you like, although not strictly necessary) and the outside diameter was increased to match the size of the 'Brembodge' group-buy discs.
They have light scratches from storage.
£40 posted for the pair.
